Discussion
Home ‣ Civil Engineering ‣ Structural Design Specifications Comments
- Question
If l is the effective span in metres and D is overall depth of the section in mm, the structure may be accepted after 24 hour load test, provided the maximum deflection in mm is less than
Options- A.
- B.
- C.
- D.
- Correct Answer
-
- 1. The slenderness ratio of single angle discontinuous struts conmected by a single rivet or bolt, shall not exceed
Options- A. 110
- B. 130
- C. 150
- D. 180 Discuss
- 2. The over all depth of a solid slab is 20 cm and effective depth is 15 cm. The horizontal distance between parallel main reinforcement should not be more than
Options- A. 30 cm
- B. 40 cm
- C. 45 cm
- D. 60 cm Discuss
- 3. Pick up the incorrect statement from the following:
Options- A. The gross section of the web of rolled I-beams is the depth of the beam multiplied by the web thickness
- B. The gross section of the web of channels is the depth of the web multiplied by its thickness
- C. The gross section of the web of plate girders is the depth of the web plate multiplied by its thinkness
- D. None of these. Discuss
- 4. In adverse circumtances, the reinforced concrete member immersed in sea water or subjected to sea spray, the maximum permissible cover for the reinforcing bars, should not exceed
Options- A. 40 mm
- B. 50 mm
- C. 60 mm
- D. 70 mm
- E. 75 mm Discuss
- 5. The grade of plain concrete to be used in sea water or structures exposed to sea water, should be
Options- A. M lO
- B. M 15
- C. M 20
- D. M 30 Discuss
- 6. The reinforcing bars in beams are not bundled in contact if the diameter of the bars, exceeds
Options- A. 12 mm
- B. 20 mm
- C. 35 mm
- D. 30 mm
- E. 36 mm Discuss
- 7. The ratio of minimum compressive strength on 15 cm cubes prepared with the concrete of M 20 grade and M 40 grade, at 7 days should be at least
Options- A. 1/3
- B. 1/2
- C. 3/2
- D. 2.0 Discuss
- 8. Moist curing of the exposed surfaces of concrete is done at least for
Options- A. 3 days
- B. 5 days
- C. 7 days
- D. 14 days Discuss
- 9. In compression members, the lap length of a bar should not be less than
Options- A. 12 ?
- B. 16 ?
- C. 20 ?
- D. 24 ?
- E. 30 ? Discuss
- 10. The grade of concrete generally not used in the reinforced concrete, is
Options- A. M 10
- B. M 15
- C. M 20
- D. M 40 Discuss
Structural Design Specifications problems
Search Results
Correct Answer: 180
Correct Answer: 45 cm
Correct Answer: The gross section of the web of channels is the depth of the web multiplied by its thickness
Correct Answer: 75 mm
Correct Answer: M 15
Correct Answer: 36 mm
Correct Answer: 1/2
Correct Answer: 7 days
Correct Answer: 24 ?
Correct Answer: M 10
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.