Discussion
Home ‣ Civil Engineering ‣ Structural Design Specifications Comments
- Question
The maximum horizontal deflection of a column of actual length L, when subjected to lateral forces, may be upto
Options- A.
- B.
- C.
- D.
- Correct Answer
-
- 1. Stress in SI units is expressed in
Options- A. kg per sq cm
- B. kg per sq mm
- C. Newton per sq mm
- D. Newton per sq cm
- E. Newton per sq m Discuss
- 2. N-s/m2 is used in S.I. system for
Options- A. Kinematic viscosity
- B. Dynamic viscosity
- C. Mass density
- D. Weight density. Discuss
- 3. Intensity of electric current is expressed in
Options- A. volts
- B. watts
- C. amperes
- D. joules. Discuss
- 4. SI unit for the surface tension, is
Options- A. kg/m3
- B. kg/m2
- C. kg/m
- D. N/m Discuss
- 5. Pick up the correct statement from the following:
Options- A. In S.I. system, pressure is expressed in N/m2
- B. In S.I. system, surface tension is expressed in Newton per metre
- C. In S.I. system, force is expressed in Newtons
- D. In S.I. system, power is expressed in watts
- E. All the above. Discuss
- 6. If ? is the deviation of the individual test strength from the average of n samples, the standard deviation of concrete of the given grade is
Options- A.
- B.
- C.
- D.
Discuss
- 7. The cover to the main reinforced may be reduced up to one third of the specified cover but not less than
Options- A. 5 mm
- B. 7 mm
- C. 10 mm
- D. 15 mm Discuss
- 8. For the stability of a structural part, the weight or anchorage should be
Options- A. 1.2 times the minimum overturning moment due to dead load
- B. 1.4 times the minimum overturning moment due to dead load
- C. sum of (a) and (b)
- D. none of these. Discuss
- 9. The grade of plain concrete to be used in sea water or structures exposed to sea water, should be
Options- A. M lO
- B. M 15
- C. M 20
- D. M 30 Discuss
- 10. In adverse circumtances, the reinforced concrete member immersed in sea water or subjected to sea spray, the maximum permissible cover for the reinforcing bars, should not exceed
Options- A. 40 mm
- B. 50 mm
- C. 60 mm
- D. 70 mm
- E. 75 mm Discuss
Structural Design Specifications problems
Search Results
Correct Answer: Newton per sq m
Correct Answer: Dynamic viscosity
Correct Answer: amperes
Correct Answer: N/m
Correct Answer: All the above.
Correct Answer:
Correct Answer: 5 mm
Correct Answer: sum of (a) and (b)
Correct Answer: M 15
Correct Answer: 75 mm
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.