logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ SI Units Comments
  • Question

  • N-s/m2 is used in S.I. system for


  • Options
  • A. Kinematic viscosity
  • B. Dynamic viscosity
  • C. Mass density
  • D. Weight density.

  • Correct Answer
  • Dynamic viscosity 

    • SI Units problems

    Search Results

    • 1. Intensity of electric current is expressed in

    • Options
    • A. volts
    • B. watts
    • C. amperes
    • D. joules.
      • Discuss
    • 2. SI unit for the surface tension, is

    • Options
    • A. kg/m3
    • B. kg/m2
    • C. kg/m
    • D. N/m
      • Discuss
    • 3. Pick up the correct statement from the following:

    • Options
    • A. In S.I. system, pressure is expressed in N/m2
    • B. In S.I. system, surface tension is expressed in Newton per metre
    • C. In S.I. system, force is expressed in Newtons
    • D. In S.I. system, power is expressed in watts
    • E. All the above.
      • Discuss
    • 4. m2/s is used in S.I. system for

    • Options
    • A. Surface tension
    • B. Kinematic viscosity
    • C. Pressure
    • D. Power.
      • Discuss
    • 5. The SI unit of the force is

    • Options
    • A. Newton
    • B. Kilogrames
    • C. Joule
    • D. Erg
      • Discuss
    • 6. Stress in SI units is expressed in

    • Options
    • A. kg per sq cm
    • B. kg per sq mm
    • C. Newton per sq mm
    • D. Newton per sq cm
    • E. Newton per sq m
      • Discuss
    • 7. The maximum horizontal deflection of a column of actual length L, when subjected to lateral forces, may be upto

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 8. If ? is the deviation of the individual test strength from the average of n samples, the standard deviation of concrete of the given grade is

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 9. The cover to the main reinforced may be reduced up to one third of the specified cover but not less than

    • Options
    • A. 5 mm
    • B. 7 mm
    • C. 10 mm
    • D. 15 mm
      • Discuss
    • 10. For the stability of a structural part, the weight or anchorage should be

    • Options
    • A. 1.2 times the minimum overturning moment due to dead load
    • B. 1.4 times the minimum overturning moment due to dead load
    • C. sum of (a) and (b)
    • D. none of these.
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.