logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ SI Units See What Others Are Saying!
  • Question

  • In SI units, moment is expressed as


  • Options
  • A. kg-m
  • B. kg-cm
  • C. kg-mm
  • D. all the above.

  • Correct Answer
  • all the above. 

    • More questions

    • 1. If the width of a simply supported beam carrying an isolated load at its centre is doubled, the deflection of the beam at the centre is changed by

    • Options
    • A. 1/2
    • B. 1/8
    • C. 2
    • D. 8
    • E. 4
      • Discuss
    • 2. Electromagnetic spectrum contains :

    • Options
    • A. gamma rays (wave length < 10-10 m)
    • B. ultraviolet rays (wave length < 10-6 m)
    • C. infrared rays (wave length < 10-4 m)
    • D. radio rays (wave length > 1 m)
    • E. All of these
      • Discuss
    • 3. The diaphragm of a stadia theodolite is fitted with two additional

    • Options
    • A. horizontal hairs
    • B. vertical hairs
    • C. horizontal and two vertical hairs
    • D. none of these.
      • Discuss
    • 4. Modified moment of inertia of sections with a single web, is equal to moment of inertia of the section about Y-Y axis at the point of maximum bending moment and is multiplied by the ratio of

    • Options
    • A. area of compression flange at the minimum bending moment to the corresponding area at the point of maximum bending moment
    • B. area of tension flange at the minimum bending moment of the corresponding area at the point of maximum bending moment
    • C. total area of flanges at the maximum bending moment to the corresponding area at the point of maximum bending moment
    • D. none of these.
      • Discuss
    • 5. Pick up the correct statement from the following:

    • Options
    • A. Runway edge from the landing side, is called threshold
    • B. Localizer indicates to the pilot his position with respect to the proposed alignment
    • C. The glide slope indicates the correct angle of descent
    • D. L.O.M. and L.M.M. help the pilot to judge his position for the runway
    • E. All the above.
      • Discuss
    • 6. The maximum energy stored at elastic limit of a material is called

    • Options
    • A. resilience
    • B. proof resilience
    • C. modulus of resilience
    • D. bulk resilience
      • Discuss
    • 7. The ratio of frictional factor and coefficient of friction used in general equation for a head loss in a pipe, is

    • Options
    • A. 1
    • B. 2
    • C. 3
    • D. 4
      • Discuss
    • 8. An aggregate is known as cyclopean aggregate if its size is more than

    • Options
    • A. 4.75 mm
    • B. 30 mm
    • C. 60 mm
    • D. 75 mm
    • E. 90 mm.
      • Discuss
    • 9. Pick up the correct statement from the following

    • Options
    • A. Approach of the water line in a flumed channel section should not be steeper than
    • B. Departure of the water line from a flumed channel section should not be steeper than 30°
    • C. Approach of the water line should not be steeper than 30° and departure line not steeper than in a flumed channel section
    • D. Approach and departure of the water line in a flumed channel section, should not be steeper than
      • Discuss
    • 10. Minimum permissible speed on high speed roads, is decided on the basis of

    • Options
    • A. 15 percentile cumulative frequency
    • B. 20 percentile cumulative frequency
    • C. 30 percentile cumulative frequency
    • D. 40 percentile cumulative frequency.
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.