logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Airport Engineering Comments

  • Question
  • The fuse large includes


  • Options
  • A. passengers chamber
  • B. pilot's cabin
  • C. tail of aircraft
  • D. all the above.

  • Correct Answer
  • all the above. 


  • Airport Engineering problems


    Search Results


    • 1. The maximum length and pavement strength of the runway is that of

    • Options
    • A. A 1
    • B. B 2
    • C. B 3
    • D. G 7
    • Discuss
    • 2. Pick up the correct statement from the following:

    • Options
    • A. The basic length of a runway is increased at a rate of 7% per 300 m of elevation of M.S.L.
    • B. The standard temperature at the site is obtained by reducing the standard sea level temperature of 15°C at the rate of 6.5°C per 1000 m rise in elevation
    • C. The aerodrome reference temperature is the monthly mean of the mean daily temperature for the hottest month of the year
    • D. All the above.
    • Discuss
    • 3. The landing and take off of the air craft is made against the direction of wind. In no case the centre line of the runway should make an angle with the wind direction exceeding

    • Options
    • A. 10°
    • B. 20°
    • C. 30°
    • D. 40°
    • Discuss
    • 4. The air is blowing at a speed of 75 knots in the direction of the aircraft flying at a ground speed of 775 knots. The air speed of the aircraft, is

    • Options
    • A. 775 knots
    • B. 75 knots
    • C. 850 knots
    • D. 675 knots
    • Discuss
    • 5. Airport elevation is the reduced level above M.S.L. of

    • Options
    • A. control tower
    • B. highest point of the landing area
    • C. lowest point of the landing area
    • D. none of these.
    • Discuss
    • 6. Pick up the correct statement from the following:

    • Options
    • A. F.I.R. stands for flight information regions
    • B. F.I.C. stands for flight information centre
    • C. Radius of control area is 160 km
    • D. Radius of control zone is 40 km
    • E. All the above.
    • Discuss
    • 7. The distance between main gears is 10 m, and the distance of nose gear from centre of main gears is 30 m. If the angle of turning is 60°, the distance of centre of rotation from the nearer main gear, is

    • Options
    • A. 12.30 m
    • B. 11.30 m
    • C. 10.30 m
    • D. 9.30 m
    • Discuss
    • 8. The runway orientation is made so that landing and take off are

    • Options
    • A. against the wind direction
    • B. along the wind direction
    • C. perpendicular to wind direction
    • D. none of these.
    • Discuss
    • 9. Pick up the correct statement from the following:

    • Options
    • A. Approximate geometric centre of the landing area, is called air port reference point
    • B. The boundaries of horizontal surface and conical surface are marked with reference to air port reference point
    • C. The location of the air port on a map is the position of air port reference point
    • D. All the above.
    • Discuss
    • 10. The bearing of the runway at threshold is 290°, the runway number is

    • Options
    • A. N 70° W
    • B. 290°
    • C. 29°
    • D. W 20° N
    • Discuss


    Comments

    There are no comments.

Enter a new Comment