Discussion
Home ‣ Civil Engineering ‣ Airport Engineering Comments
- Question
The maximum length and pavement strength of the runway is that of
Options- A. A 1
- B. B 2
- C. B 3
- D. G 7
- Correct Answer
- A 1
- 1. Pick up the correct statement from the following:
Options- A. The basic length of a runway is increased at a rate of 7% per 300 m of elevation of M.S.L.
- B. The standard temperature at the site is obtained by reducing the standard sea level temperature of 15°C at the rate of 6.5°C per 1000 m rise in elevation
- C. The aerodrome reference temperature is the monthly mean of the mean daily temperature for the hottest month of the year
- D. All the above. Discuss
- 2. The landing and take off of the air craft is made against the direction of wind. In no case the centre line of the runway should make an angle with the wind direction exceeding
Options- A. 10°
- B. 20°
- C. 30°
- D. 40° Discuss
- 3. The air is blowing at a speed of 75 knots in the direction of the aircraft flying at a ground speed of 775 knots. The air speed of the aircraft, is
Options- A. 775 knots
- B. 75 knots
- C. 850 knots
- D. 675 knots Discuss
- 4. Airport elevation is the reduced level above M.S.L. of
Options- A. control tower
- B. highest point of the landing area
- C. lowest point of the landing area
- D. none of these. Discuss
- 5. The bearing of the longest line of a wind rose is S 45° E, the bearing of the runway will be numbered
Options- A. 135°
- B. 315°
- C. 13
- D. 31
- E. both (c) and (d) Discuss
- 6. The fuse large includes
Options- A. passengers chamber
- B. pilot's cabin
- C. tail of aircraft
- D. all the above. Discuss
- 7. Pick up the correct statement from the following:
Options- A. F.I.R. stands for flight information regions
- B. F.I.C. stands for flight information centre
- C. Radius of control area is 160 km
- D. Radius of control zone is 40 km
- E. All the above. Discuss
- 8. The distance between main gears is 10 m, and the distance of nose gear from centre of main gears is 30 m. If the angle of turning is 60°, the distance of centre of rotation from the nearer main gear, is
Options- A. 12.30 m
- B. 11.30 m
- C. 10.30 m
- D. 9.30 m Discuss
- 9. The runway orientation is made so that landing and take off are
Options- A. against the wind direction
- B. along the wind direction
- C. perpendicular to wind direction
- D. none of these. Discuss
- 10. Pick up the correct statement from the following:
Options- A. Approximate geometric centre of the landing area, is called air port reference point
- B. The boundaries of horizontal surface and conical surface are marked with reference to air port reference point
- C. The location of the air port on a map is the position of air port reference point
- D. All the above. Discuss
Airport Engineering problems
Search Results
Correct Answer: All the above.
Correct Answer: 30°
Correct Answer: 675 knots
Correct Answer: highest point of the landing area
Correct Answer: both (c) and (d)
Correct Answer: all the above.
Correct Answer: All the above.
Correct Answer: 12.30 m
Correct Answer: against the wind direction
Correct Answer: All the above.
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.