Discussion
Home ‣ Civil Engineering ‣ Water Supply Engineering Comments
- Question
Pick up the incorrect statement from the following. The underground sources of water, is from
Options- A. wells
- B. springs
- C. infiltration wells
- D. storage reservoirs
- E. none of these.
- Correct Answer
- storage reservoirs
- 1. If V is total consumption of water in litres for a population of N individuals, per capita consumption or water allowance for the water supply Q, is given by
Options- A.
- B.
- C.
- D. none of these. Discuss
- 2. The factor affecting per capita demand, is
Options- A. size of the city
- B. climatic conditions
- C. pressure in water mains
- D. cost of water
- E. all the above. Discuss
- 3. Disinfection of drinking water, is done to remove
Options- A. odour
- B. bacterias
- C. turbidity
- D. colour. Discuss
- 4. Acidity in water is caused due to
Options- A. Mineral acids
- B. Free CO2
- C. Iron sulphate
- D. Aluminium sulphate
- E. All the above. Discuss
- 5. B.O.D. of treated water should be
Options- A. 10 ppm
- B. 25 ppm
- C. 20 ppm
- D. 30 ppm
- E. Nil. Discuss
- 6. Pick up the correct statement from the following :
Options- A. Excess quantities of iron and manganese in water, cause discolouration of clothes
- B. Lead and barium salts have toxic effect
- C. Arsenic and selenium are poisonous to human health
- D. Higher copper content affects the lungs
- E. All the above. Discuss
- 7. The R.L. of ground water table on the sides of a valley is 1505 m whereas R.L. of the stream water is 1475 m. If 60° slope consists of pervious soil between R.L. 1485 m to 1500 m, the gravity spring may be expected at the point of reduced level
Options- A. 1500 m
- B. 1505 m
- C. 1475 m
- D. 1485 m. Discuss
- 8. In distribution pipes, drain valves are provided at
Options- A. lower point
- B. higher point
- C. junction points
- D. any where. Discuss
- 9. Distribution mains of any water supply, is normally designed for its average daily requirement
Options- A. 100%
- B. 150%
- C. 200%
- D. 225%. Discuss
- 10. Corrosion of well pipes may not be reduced by
Options- A. reducing the draw down and the pumping rate
- B. reducing the flow velocity
- C. using thicker pipes
- D. using screens having larger area of openings
- E. none of these. Discuss
Water Supply Engineering problems
Search Results
Correct Answer:
Correct Answer: all the above.
Correct Answer: bacterias
Correct Answer: All the above.
Correct Answer: Nil.
Correct Answer: All the above.
Correct Answer: 1485 m.
Correct Answer: lower point
Correct Answer: 225%.
Correct Answer: using screens having larger area of openings
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.