Discussion
Home ‣ Civil Engineering ‣ Strength of Materials Comments
- Question
The minimum number of rivets for the connection of a gusset plate, is
Options- A. 1
- B. 2
- C. 3
- D. 4
- Correct Answer
- 2
- 1. A shaft turning 150 r.p.m. is subjected to a torque of 150 kgm. Horse power transmitted by the shaft is
Options- A. ?
- B. 10 ?
- C. ?2
- D. 1/? Discuss
- 2. In a tension test, the yield stress is 300 kg/cm2, in the octa hedral shear stress at the point is:
Options- A. 100 2 kg/cm2
- B. 150 2 kg/cm2
- C. 200 2 kg/cm
- D. 250 2 kg/cm2. Discuss
- 3. Pick up the incorrect statement
Options- A. The cross-sectional area of the welded member is effective
- B. A welded joint develops strength of its parent metal
- C. Welded joints provide rigidity
- D. Welded joints have better finish
- E. Welding takes more time than riveting. Discuss
- 4. A uniform girder simply supported at its ends is subjected to a uniformly distributed load over its entire length and is propped at the centre so as to neutralise the deflection. The net B.M. at the centre will be
Options- A. WL
- B.
- C.
- D.
- E.
Discuss
- 5. If the shear force along a section of a beam is zero, the bending moment at the section is
Options- A. zero
- B. maximum
- C. minimum
- D. average of maximum-minimum
- E. none of these. Discuss
- 6. If the width of a simply supported beam carrying an isolated load at its centre is doubled, the deflection of the beam at the centre is changed by
Options- A. 1/2
- B. 1/8
- C. 2
- D. 8
- E. 4 Discuss
- 7. The deflection of any rectangular beam simply supported, is
Options- A. directly proportional to its weight
- B. inversely proportional to its width
- C. inversely proportional to the cube of its depth
- D. directly proportional to the cube of its length
- E. none of these. Discuss
- 8. In a beam, the neutral plane
Options- A. may be its centre
- B. passes through the C.G. of the area of cross-section
- C. does not change during deformation
- D. none of these. Discuss
- 9. Shrouding is provided in
Options- A. cavity type tube wells
- B. slotted type tube wells
- C. strainer type tube wells
- D. perforated type tube wells. Discuss
- 10. Consumptive use of a crop during growth, is the amount of
Options- A. interception
- B. transpiration
- C. evaporation
- D. all the above. Discuss
Strength of Materials problems
Search Results
Correct Answer: 10 ?
Correct Answer: 100 2 kg/cm2
Correct Answer: Welding takes more time than riveting.
Correct Answer:
Correct Answer: maximum
Correct Answer: 1/2
Correct Answer: inversely proportional to the cube of its depth
Correct Answer: does not change during deformation
Correct Answer: slotted type tube wells
Correct Answer: all the above.
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.