logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Concrete Technology Comments

  • Question
  • Wp and Wf are the weights of a cylinder containing partially compacted and fully compacted concrete. If the compaction factor Wp and Wf are the weights of a cylinder containing partially compacted and fully compacted concrete. is 0.95, the workability of concrete is


  • Options
  • A. extremely low
  • B. very low
  • C. low
  • D. high
  • E. none of these.

  • Correct Answer
  • high 


  • Concrete Technology problems


    Search Results


    • 1. Hydration of cement is due to chemical action of water with

    • Options
    • A. Tricalcium silicate and dicalcium silicate
    • B. Dicalcium silicate and tricalcium aluminate
    • C. Tricalcium aluminate and tricalcium alumino ferrite
    • D. All the above.
    • Discuss
    • 2. For providing a raft foundation, the following activities are involved

      1. ramming the foundation bed
      2. excavation of the soil upto required depth
      3. laying the reinforcement over the foundation bed
      4. curing the cement concrete placed over reinforcement
      5. pouring the cement concrete over the reinforcement.

      The correct sequence is

    • Options
    • A. 1, 2, 3, 4, 5
    • B. 5, 4, 3, 2, 1
    • C. 2, 1, 3, 5, 4
    • D. 3, 2, 5, 1, 4.
    • Discuss
    • 3. The single stage well point system of dewatering an excavation can be used if the depth of excavation does not exceed

    • Options
    • A. 5 m
    • B. 10 m
    • C. 15 m
    • D. 20 m
    • E. 25 m.
    • Discuss
    • 4. If (?) is the angle of repose of soil of weight w kg/m3, the horizontal pressure p at a depth of h metres per metre length of wall, is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 5. During percussion drilling

    • Options
    • A. ground water observations are hindered due to entry of the slurry in the soil below the bottom of the hole
    • B. caving or mixing of strata are caused in soft soils or cohesionless soils
    • C. the soil to a considerable depth below the bottom of the hole gets disturbed
    • D. all the above.
    • Discuss
    • 6. The commonly used material in the manufacture of cement is

    • Options
    • A. sand stone
    • B. slate
    • C. lime stone
    • D. graphite.
    • Discuss
    • 7. Slump test is done for

    • Options
    • A. clay
    • B. sand
    • C. lime
    • D. concrete.
    • Discuss
    • 8. Internal friction between the ingredients of concrete, is decreased by using

    • Options
    • A. less water
    • B. fine aggregates
    • C. rich mix
    • D. more water and coarse aggregates
    • E. none of these.
    • Discuss
    • 9. If 20 kg of coarse aggregate is sieved through 80 mm, 40 mm, 20 mm, 10 mm, 4.75 mm, 2.36 mm, 1.18 mm, 600 micron, 300 micron and 150 micron standard sieves and the weights retained are 0 kg, 2 kg, 8 kg, 6 kg, 4 kg respectively, the fineness modulus of the aggregate, is

    • Options
    • A. 7.30
    • B. 7.35
    • C. 7.40
    • D. 7.45
    • E. none of these.
    • Discuss
    • 10. The mixture of different ingredients of cement, is burnt at

    • Options
    • A. 1000°C
    • B. 1200°C
    • C. 1400°C
    • D. 1600°C
    • E. 1800°C
    • Discuss


    Comments

    There are no comments.

Enter a new Comment