Discussion
Home ‣ Civil Engineering ‣ Building Construction Comments
- Question
Queen closer may be placed
Options- A. in header course
- B. in stretcher course
- C. in header course next to first brick
- D. in stretcher course next to first brick
- E. in any position.
- Correct Answer
- in header course next to first brick
- 1. According to Rankine's formula, minimum depth of foundations, is
Options- A.
- B.
- C.
- D.
Discuss
- 2. The taper of precast concrete pile should not be more than
Options- A. 1 cm per metre length
- B. 2 cm per metre length
- C. 4 cm per metre length
- D. 5 cm per metre length. Discuss
- 3. Which one of the following rocks is used for monumental buildings :
Options- A. granite
- B. marble
- C. sand stone
- D. slate. Discuss
- 4. The 9 cm x 9 cm side of a brick as seen in the wall face, is generally known as
Options- A. stretcher
- B. face
- C. front
- D. header
- E. side. Discuss
- 5. The exterior angle between outer faces of a wall, is known as
Options- A. turn
- B. junction
- C. quion
- D. all the above. Discuss
- 6. The pile which is provided with a bulb filled with concrete at its lower end, is known as
Options- A. Simplex pile
- B. Mac-Arthur pile
- C. Raymond pile
- D. Franki pile
- E. none of these. Discuss
- 7. Which one of the following factors is considered for the orientation of buildings :
Options- A. the direction of the prevailing winds in the area
- B. the exposure of the walls and roof of the buildings to the rays of sun
- C. the extent up to which the sunrays penetrate with the verandah.
- D. all the above. Discuss
- 8. Pick up the correct statement from the following:
Options- A. Louvered door is generally provided in bath rooms
- B. Flush door is generally provided in dinning room
- C. Revolving door is generally provided in cinema halls
- D. Sliding door is generally provided in show rooms
- E. All the above. Discuss
- 9. A projecting piece usually provided to support a truss, is
Options- A. cornice
- B. coping
- C. frieze
- D. lintal. Discuss
- 10. To ensure that supporting area of an offset footing of a boundary wall is fully compressive, the C.G. of load must act
Options- A. at the centre of the base
- B. within the middle third of the base
- C. within the middle fifth of the base
- D. neither (a), (b) nor (c). Discuss
Building Construction problems
Search Results
Correct Answer:
Correct Answer: 2 cm per metre length
Correct Answer: marble
Correct Answer: header
Correct Answer: quion
Correct Answer: Mac-Arthur pile
Correct Answer: all the above.
Correct Answer: Revolving door is generally provided in cinema halls
Correct Answer: frieze
Correct Answer: within the middle third of the base
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.