logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Building Construction Comments

  • Question
  • Pick up the correct statement from the following :


  • Options
  • A. inclined borings are made for taking samples under existing structures
  • B. inclined borings are occasionally used instead of vertical holes.
  • C. the spacing of inclined borings is kept such that one bore hole is vertically above the bottom of an adjacent bore hole.
  • D. all the above.

  • Correct Answer
  • all the above. 


  • Building Construction problems


    Search Results


    • 1. The member which is placed horizontally to support common rafter of a sloping roof, is

    • Options
    • A. purlin
    • B. cleat
    • C. batten
    • D. strut.
    • Discuss
    • 2. In case of Raymond pile

    • Options
    • A. lengths vary from 6 m to 12 m
    • B. diameter of top of piles varies from 40 cm to 60 cm
    • C. diameter of pile at bottom varies from 20 cm to 28 cm
    • D. thickness of outer shell depends upon pile diameter
    • E. all the above.
    • Discuss
    • 3. Black cotton soil is unsuitable for foundations because its

    • Options
    • A. bearing capacity is low
    • B. permeability is uncertain
    • C. particles are cohesive
    • D. property to undergo a volumetric change due to variation of moisture content.
    • Discuss
    • 4. The line of intersection of the surfaces of a sloping roof forming an external angle exceeding 180°, is

    • Options
    • A. ridge
    • B. hip
    • C. valley
    • D. none of these.
    • Discuss
    • 5. In jack arch floor, the rise is kept

    • Options
    • A. 1/6th of the span
    • B. 1/8th of the span
    • C. 1/10th of the span
    • D. 1/12th of the span
    • E. 1/15th of the span.
    • Discuss
    • 6. The under surface of an arch, is called

    • Options
    • A. soffit
    • B. intrados
    • C. haunch
    • D. back.
    • Discuss
    • 7. While designing a stair, the product of rise and going is approximately kept equal to

    • Options
    • A. 350
    • B. 420
    • C. 450
    • D. 500
    • E. 600.
    • Discuss
    • 8. The concrete slump recommended for beams and slabs ; is

    • Options
    • A. 25 to 50 mm
    • B. 25 to 75 mm
    • C. 30 to 125 mm
    • D. 50 to 100 mm
    • E. none of these.
    • Discuss
    • 9. A wooden block hinged on post outside a door, is known

    • Options
    • A. cleat
    • B. stop
    • C. horn
    • D. none of these.
    • Discuss
    • 10. In horizontal D.P.C, thickness of cement concrete (1 : 2 : 4) is

    • Options
    • A. 2 cm
    • B. 4 cm
    • C. 6 cm
    • D. 8 cm
    • E. 10 cm.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment