Pick up the correct statement from the following: The estimated value of the wor

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Civil Engineering ‣ Estimating and Costing Comments

Question
Pick up the correct statement from the following:
Options
A. The estimated value of the work excluding the amount for contigencies, work charged establishment, tool and plants, is called work value
B. The actual expenditure involved to complete a work including incidental, establishment and travelling charges, is called actual cost
C. The formal acceptance by the administrative department for incurring an expenditure on the work, is called administrative approval
D. The order of a competent authority sanctioning a properly detailed estimate of the cost of a work of construction or repair is called technical sanction
E. All the above.

Correct Answer

All the above.

Estimating and Costing problems

Search Results

2. While preparing a detailed estimate
Options
A. Dimension should be measured correct to 0.01 m
B. Area should be measured correct to 0.01 sqm
C. Volume should be measured correct to O.Olcum
D. All the above.

4. Pick up the correct statement in case of water supply.
Options
A. Pipes laid in trenches and pipes fixed to walls are measured separately
B. Cutting through walls and floors are included with the item
C. Pipes are classified according to their sizes and quality
D. In laying pipes, the method of jointing and fixing is specifically specified
E. All the above.

6. While estimating a reinforced cement structure, the omitted cover of concrete is assumed
Options
A. at the end of reminforcing bar, not less than 25 mm or twice the diameter of the bar
B. in thin slabs, 12 mm minimum or diameter of the bar whichever is more
C. for reinforcing longitudinal bar in a beam 25 mm minimum or diameter of the largest bar which is more
D. All the above.

9. The reduced levels of points, 30 metres apart along the longitudinal section of a road portion between chainages 5 and 9 are shown in the given figure. If there is a uniform up-gradient of the road 120 in 1, the chainage of the point with no filling or cutting is
Options
A. (6 + 15) chains
B. (6 + 12) chains
C. (6 + 18) chains
D. None of these.

10. Pick up the incorrect statement from the following:
Options
A. Dimensions are measured to the nearest 0.01 m
B. Areas are measured to the nearest 0.01 sq.m
C. Cubic contents are measured to the nearest 0.1 cm m
D. Weights are measured to the nearest 0.001 tonnes

Comments

More in Civil Engineering: