logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ Railways Comments
  • Question

  • Pick up the incorrect statement from the following:


  • Options
  • A. Sleepers hold the rails at proper gauge on straights
  • B. Sleepers provide stability to the permanent way
  • C. Sleepers act as an elastic cushion between rails and ballast
  • D. Sleepers transfer load of moving trains to ballast
  • E. None of the these.

  • Correct Answer
  • None of the these. 

    • Railways problems

    Search Results

    • 1. Rails are bent to correct curvature if the degree of curve, is more than

    • Options
    • A. 1°
    • B. 2°
    • C. 3°
    • D. 4°
    • E. 6°
      • Discuss
    • 2. Wooden sleepers used on the girders of bridges, are generally made of

    • Options
    • A. sal
    • B. chir
    • C. teak
    • D. deodar.
      • Discuss
    • 3. Coal ash (or cinder) is used in initial stages of a new construction of railway for

    • Options
    • A. wooden sleepers
    • B. steel sleepers
    • C. cast iron sleepers
    • D. none of these.
      • Discuss
    • 4. Charles Vignoles invented the flat footed rails in

    • Options
    • A. 1814
    • B. 1836
    • C. 1846
    • D. 1856
    • E. 1873
      • Discuss
    • 5. If q is the discharge per unit width of a channel and D1 D2 are the depths of water before and after hydraulic jump, the following relationship is true

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 6. If L1 and L2 are actual and theoretical lengths of a tongue rail, d is heel divergence and t is thickness of tongue rail at toe, the switch angle ? is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
      • Discuss
    • 7. Dimensions of a plate girder, are :

    • Options
    • A. 851 mm x 851 mm
    • B. 255 mm x 254 mm
    • C. 851 mm x 254 mm
    • D. 551 mm x 254 mm
      • Discuss
    • 8. Best ballast contains stones varying in size from

    • Options
    • A. 1.5 cm to 3 cm
    • B. 2.0 cm to 4 cm
    • C. 2.0 cm to 5 cm
    • D. 2.5 cm to 6 cm
      • Discuss
    • 9. Minimum depth of ballast prescribed of B.G. trunk lines of Indian Railways, is

    • Options
    • A. 20 cm
    • B. 15 cm
    • C. 25 cm
    • D. 30 cm
    • E. 35 cm
      • Discuss
    • 10. To design a cross-over between parallel tracks, the required components are :

    • Options
    • A. two switch, points, two acute angle crossings and two check rails
    • B. two switch points, two acute angle crossings and four check rails
    • C. two switch points, two acute angle crossings and six check rails
    • D. none of these.
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.