logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Irrigation Comments

  • Question
  • For designing the venturi head,


  • Options
  • A. width of the throat should not be less than one-third of the bed width of main canal
  • B. width of the throat should not be less than the width obtained from the formula B = Q / 1.2d3/2, where d is the difference in levels of F.S.L. and sill
  • C. minimum throat width should not be less than 60 cm
  • D. length of the throat should be 2.5 times the depth measured to F.S.L. in the main canal
  • E. all the above.

  • Correct Answer
  • all the above. 


  • Irrigation problems


    Search Results


    • 1. If L is total length of a canal in kilometres, P is total perimeter of its lining in metres and C is the cost of lining per square metre, the additional expenditure involved on lining, is

    • Options
    • A. 1000 PLC
    • B.
    • C.
    • D.
    • Discuss
    • 2. Borrow pits should preferably be located in

    • Options
    • A. field on the left side of the canal
    • B. field on the right side of the canal
    • C. fields on both sides of the canal
    • D. central half width of the section of the canal.
    • Discuss
    • 3. The intensity of irrigation means

    • Options
    • A. percentage of culturable commanded area to be irrigated annually
    • B. percentage of gross commanded area to be irrigated annually
    • C. percentage of the mean of culturable commanded area and the gross commanded area to be irrigated annually
    • D. total depth of water supplied by the number of waterings.
    • Discuss
    • 4. Pick up the correct statement from the following:

    • Options
    • A. If the flexibility is more than one, the outlet is hyper-proportional
    • B. If the setting of an outlet is higher than that required for proportionality, the outlet is hyper-proportional
    • C. If the setting of an outlet is lower than that required for proportionality, the outlet is sub-proportional
    • D. If the flexibility is zero, it is a rigid module
    • E. All the above.
    • Discuss
    • 5. For smooth entry of water in a canal, the angle between head regulator and water is generally kept

    • Options
    • A. 80°
    • B. 90°
    • C. 110°
    • D. 120°
    • Discuss
    • 6. When a canal is carried over a natural drainage, the structure provided, is known as

    • Options
    • A. syphon
    • B. aqueduct
    • C. super passage
    • D. syphon-aqueduct.
    • Discuss
    • 7. Attracting groynes are built

    • Options
    • A. perpendicular to the bank
    • B. inclined down stream
    • C. inclined up stream
    • D. none of these.
    • Discuss
    • 8. Pick up the incorrect statement from the following

    • Options
    • A. A bank in the cross-section of a canal is provided on the right
    • B. A bank in the cross-section of a canal is provided on the left
    • C. A 'dowla' in the cross-section of a canal is provided on the left
    • D. None of these.
    • Discuss
    • 9. The saturation line is the line up to which banks get saturated after the canal runs for some time. The saturation gradient in ordinary loam soil, is generally

    • Options
    • A. 2 : 1
    • B. 3 : 1
    • C. 4 : 1
    • D. 5 : 1
    • E. 6 : 1
    • Discuss
    • 10. Pick up the correct statement from the following

    • Options
    • A. Approach of the water line in a flumed channel section should not be steeper than
    • B. Departure of the water line from a flumed channel section should not be steeper than 30°
    • C. Approach of the water line should not be steeper than 30° and departure line not steeper than in a flumed channel section
    • D. Approach and departure of the water line in a flumed channel section, should not be steeper than
    • Discuss


    Comments

    There are no comments.

Enter a new Comment