Discussion
Home ‣ Civil Engineering ‣ RCC Structures Design Comments
- Question
The number of treads in a flight is equal to
Options- A. risers in the flight
- B. risers plus one
- C. risers minus one
- D. none of these.
- Correct Answer
- risers minus one
- 1. Design of R.C.C. simply supported beams carrying U.D.L. is based on the resultant B.M. at
Options- A. supports
- B. mid span
- C. every section
- D. quarter span. Discuss
- 2. The transverse reinforcements provided at right angles to the main reinforcement
Options- A. distribute the load
- B. resist the temperature stresses
- C. resist the shrinkage stress
- D. all the above. Discuss
- 3. If the average bending stress is 6 kg/cm2 for M 150 grade concrete, the length of embedment of a bar of diameter d according to I.S. 456 specifications, is
Options- A. 28 d
- B. 38 d
- C. 48 d
- D. 58 d
- E. 95 d Discuss
- 4. An R.C.C. column is treated as long if its slenderness ratio is greater than
Options- A. 30
- B. 35
- C. 40
- D. 50
- E. 60 Discuss
- 5. A continuous beam shall be deemed to be a deep beam if the ratio of effective span to overall depth, is
Options- A. 2.5
- B. 2.0
- C. less than 2
- D. less than 2.5 Discuss
- 6. Post tensioning system
Options- A. was widely used in earlier days
- B. is not economical and hence not generally used
- C. is economical for large spans and is adopted now a days
- D. none of these. Discuss
- 7. The amount of reinformcement for main bars in a slab, is based upon
Options- A. minimum bending moment
- B. maximum bending moment
- C. maximum shear force
- D. minimum shear force. Discuss
- 8. The advantage of a concrete pile over a timber pile, is
Options- A. no decay due to termites
- B. no restriction on length
- C. higher bearing capacity
- D. not necessary to cut below the water mark
- E. all the above. Discuss
- 9. The width of the flange of a T-beam should be less than
Options- A. one-third of the effective span of the T-beam
- B. distance between the centres of T-beam
- C. breadth of the rib plus twelve times the thickness of the slab
- D. least of the above. Discuss
- 10. High strength concrete is used in prestressed member
Options- A. to overcome high bearing stresses developed at the ends
- B. to ovecome bursting stresses at the ends
- C. to provide high bond stresses
- D. to overcome cracks due to shrinkage
- E. all the above. Discuss
RCC Structures Design problems
Search Results
Correct Answer: mid span
Correct Answer: all the above.
Correct Answer: 58 d
Correct Answer: 50
Correct Answer: 2.5
Correct Answer: none of these.
Correct Answer: maximum bending moment
Correct Answer: all the above.
Correct Answer: least of the above.
Correct Answer: all the above.
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.