Discussion
Home ‣ Civil Engineering ‣ Soil Mechanics and Foundation Engineering Comments
- Question
The effective size of particles of soil is denoted by
Options- A. D10
- B. D20
- C. D30
- D. D60
- Correct Answer
- D10
- 1. Pick up the correct statement from the following:
Options- A. Sandy clayloam contains highest percentage of sand
- B. Silty clayloam contains highest percentage of silt
- C. Stiff boulder clay offers maximum shear strength
- D. Soft chalk carries least safe load
- E. All the above. Discuss
- 2. According to Coulomb's wedge theory, the active earth pressure slides the wedge
Options- A. down and outwards on a slip surface
- B. up and inwards on a slip surface
- C. horizontal upward and parallel to base
- D. horizontal inward and parallel to base. Discuss
- 3. The minimum water content at which the soil retains its liquid state and also possesses a small shearing strength against flowing, is known
Options- A. liquid limit
- B. plastic limit
- C. shrinkage limit
- D. permeability limit. Discuss
- 4. The weight of a pycnometer containing 400 g sand and water full to the top is 2150 g. The weight of pycnometer full of clean water is 1950 g. If specific gravity of the soil is 2.5, the water content is
Options- A. 5%
- B. 10%
- C. 15%
- D. 20% Discuss
- 5. The active earth pressure of a soil is proportional to (where ? is the angle of friction of the soil)
Options- A. tan (45° - ?)
- B. tan2 (45° + ?/2)
- C. tan2 (45° - ?/2)
- D. tan (45° + ?) Discuss
- 6. The coefficient of compressibility of soil, is the ratio of
Options- A. stress to strain
- B. strain to stress
- C. stress to settlement
- D. rate of loading to that of settlement. Discuss
- 7. If the failure of a finite slope occurs through the toe, it is known as
Options- A. slope failure
- B. face failure
- C. base failure
- D. toe failure. Discuss
- 8. The fluid generally used for grouting is
Options- A. cement and water mix
- B. clay suspension
- C. sodium silicate
- D. bitumen emulsion
- E. all the above. Discuss
- 9. The water content of soil is defined as the ratio of
Options- A. volume of water to volume of given soil
- B. volume of water to volume of voids in soil
- C. weight of water to weight of air in voids
- D. weight of water to weight of solids of given mass of soil. Discuss
- 10. Pick up the clay soil group which does not swell when wet from the following :
Options- A. Kaolinite group
- B. Mite group
- C. Vermiculite group
- D. Montrorillonite group. Discuss
Soil Mechanics and Foundation Engineering problems
Search Results
Correct Answer: Silty clayloam contains highest percentage of silt
Correct Answer: down and outwards on a slip surface
Correct Answer: liquid limit
Correct Answer: 20%
Correct Answer: tan2 (45° - ?/2)
Correct Answer: strain to stress
Correct Answer: toe failure.
Correct Answer: all the above.
Correct Answer: weight of water to weight of solids of given mass of soil.
Correct Answer: Mite group
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.