Which Stack is used in 8085?

Correct Answer: The Micro Processor enters into Halt-State and the buses are tri-stated

Correct Answer: Three Logic Levels are used and they are High, Low, HIgh impedance state The high and low are normal logic levels & high impedance state is electrical open circuit conditions Tri-state logic has a third line called enable line

Correct Answer: Because of high stability, large Q (Quality Factor) & the frequency that doesn't drift with aging Crystal is used as a clock source most of the times

Correct Answer: In 8086 Carry flag, Parity flag, Ausiliary carry flag, Zero flag, Overflow flag, Trace flag, Interrupt flag, Direction flag, and Sing flag

Correct Answer: 1 Address lines to refer to the address of a block 2 Data lines for data transfer 3 IC chips 4 Processing data

Correct Answer: Accumulator register, Temporary register, Instruction register, Stack Pointer, Program Counter are the various registers in 8085

Correct Answer: IEEE 1394 (Firewire) supports the maximum of 63 connected devices with speeds up to 400 Mbps

Correct Answer: Byte contains 8 combinations of bits

Correct Answer: There are three types of buses Address bus: This is used to carry the Address to the memory to fetch either Instruction or Data Data bus: This is used to carry the Data from the memory Control bus: This is used to carry the Control signals like RD/WR, Select etc

Correct Answer: An interrupt that can be turned off by the programmer is known as Maskable interrupt