For an atom to emit X-rays it should have difference in energy levels
Silver is the best conductor of both heat and electricity among metals with a thermal conduction value of about 430 W/(mK).
Gold and copper both come respectably close to silver.
Copper being significantly less costly it is often chosen over silver in many applications.
Any object rolls when there is no friction. So, Sliding to Rolling is correct.
Electrical Pressure is also called as Voltage. Voltage is measured in Volts.
Volt : A unit of electrical pressure or Voltage is called Volt.
One volt is the amount of pressure required to cause one ampere of current to flow against one ohm of resistance.
Voltage is also referred to as Electromotive Force or Electrical Potential or Electrical Pressure.
The power source such as a Battery of an IED creates an electrical charge.
What are IED's ::
An Improvised Explosive Device (IED) is a bomb constructed and deployed in ways other than in conventional military action. It may be constructed of conventional military explosives, such as an artillery shell, attached to a detonating mechanism. IEDs are commonly used as roadside bombs.
When the switch is ON, in a tube light choke is nothing but the coil/ballast ( inductor) which is used to induce the high voltage across it. as we know that inductor has property to induce high voltage for the brief period of time, this high voltage is required to ionize the gases in the starter.
Then gas inside the starter gets ionized due to this full voltage and heats the bimetallic strip that is caused to be bent to connect to the fixed contact. Current starts flowing through the starter. Although the ionization potential of the neon is the little bit more than that of the argon but still due to small electrode gap high voltage gradient is appeared in the neon bulb and hence glow discharge is started first in a starter.
As voltage gets reduced due to the current causes a voltage drop across the inductor, the strip cools and breaks away from the fixed contact. At that moment a large L di/dt voltage surge comes across the inductor at the time of breaking.
This high valued surge comes across the tube light electrodes and strikes penning mixture (mixture argon gas and mercury vapor).
Gas discharge process continues and current gets the path to flow through the tube light gas only due to low resistance as compared to the resistance of starter.
Comments
There are no comments.Copyright ©CuriousTab. All rights reserved.