Discussion
Home ‣ General Knowledge ‣ Computer Comments
- Question
Which of the following could be digital input devices for computers?
Options- A. Digital camcorder
- B. Microphone
- C. Scanner
- D. All of the above
- Correct Answer
- All of the above
- 1. Compatibility in regard to computers refers to ________
Options- A. The software doing the right job for the user
- B. It being versatile enough to handle the job
- C. The software being able to run on the computer
- D. Software running with other previously installed software Discuss
- 2. Which of the following are advantage of CD-ROM as a storage media?
Options- A. CD-ROM is an inexpensive way to store large amount of data and information
- B. CD-ROM disks retrieve data and information more quickly than magnetic disks do
- C. CD-ROMS make less errors than magnetic media
- D. All of these Discuss
- 3. Programs designed specifically to address general purpose applications and special-purpose applications are called ......
Options- A. Management Information System
- B. System Software
- C. Application Software
- D. None of these Discuss
- 4. Storage capacity of magnetic disk depends on
Options- A. disk pack in disk surface
- B. tracks per inch of surface
- C. bits per inch of tracks
- D. All of the above Discuss
- 5. What is a default file extension for all word documents?
Options- A. TXT
- B. WRD
- C. FIL
- D. DOC Discuss
- 6. A removable magnetic disc that holds information ______
Options- A. Floppy disk
- B. Hard drive
- C. Monitor
- D. Portable Discuss
- 7. Which of the following software applications would be the most appropriate for performing numerical and statistical calculations?
Options- A. Database
- B. Document Processor
- C. Graphic Package
- D. Spread Sheet Discuss
- 8. The _____ controls communications for the entire computer system
Options- A. arithmetic-logic unit
- B. semiconductor
- C. motherboard
- D. coprocessor Discuss
- 9. When you cut or copy information it gets place in the___________
Options- A. Clipboard
- B. Mother board
- C. RAM
- D. None of these Discuss
- 10. The symbols used in an assembly language are called ?
Options- A. Assembler
- B. Mnemonics
- C. Codes
- D. All of the above Discuss
Computer problems
Search Results
Correct Answer: Software running with other previously installed software
Correct Answer: CD-ROM is an inexpensive way to store large amount of data and information
Correct Answer: Application Software
Correct Answer: All of the above
Correct Answer: DOC
Correct Answer: Floppy disk
Correct Answer: Spread Sheet
Correct Answer: motherboard
Correct Answer: Clipboard
Correct Answer: Mnemonics
Comments
There are no comments.More in General Knowledge:
Programming
Copyright ©CuriousTab. All rights reserved.